[bug-pcl] could not build the Ghostpcl source in MSVC

[Stefan Kemper]

Comment the block out, that should take care of it till we release
again.

# !if $(COMPILE_INITS)
# ZM=/Zm600
# !else
# ZM=
# !endif

On Mon, 2004-06-21 at 06:56, Cecilia wrote:
> Hello!!
>  
> I am trying to use the Ghostpcl software for file conversion from pcl
> to bmp format. I was not able to build the GhostPCL source code in
> Microsoft Visual studio. I followed the instructions given in
> GhostPCL.pdf document, But when I try to build the
> makefile(main/pcl6_msvc.mak) in MSVC, it gives the
> following error.....".\gs\src\msvccmd.mak(178) : fatal error U1018:
> directive and/or expression part missing" at the below portion of the
> makefile 
>  
> !if $(COMPILE_INITS)
> ZM=/Zm600
> !else
> ZM=
> !endif
>  
> Would be very greatful if you could tell me the solution to
> this problem ? 
>  
> Regards,
> Cecilia
> 
> 
>  
> 
> 
> 
> ______________________________________________________________________
> _______________________________________________
> bug-pcl mailing list
> bug-pcl at ghostscript.com
> http://www.ghostscript.com/mailman/listinfo/bug-pcl