[gs-bugs] [Bug 691486] PDF 1.7 FTS: 3D not supported

[bugzilla-daemon at ghostscript.com]

http://bugs.ghostscript.com/show_bug.cgi?id=691486

--- Comment #4 from Alex Cherepanov <alex.cherepanov at artifex.com> 2010-07-24 22:56:01 UTC ---
Created an attachment (id=6544)
 --> (http://bugs.ghostscript.com/attachment.cgi?id=6544)
patch

Render 3D annotations (using appearance stream) on the printer device even
if Print flag (0x4) is not set. This is done following AR8 and AR9 example
but contrary to PDF 1.7 spec.

Currently, /Printed attribute is set when currentpagedevice has /OutputFile
attribute. The customer, probably, needs to define /Printed attribute
explicitly.

Rendering of 3D annotations without appearance streams is a big project
that goes beyond this bug report.

-- 
Configure bugmail: http://bugs.ghostscript.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the QA contact for the bug.