[gs-devel] gs on uClinux ARM producing blank output

[James Maki]

I have cross-compiled gs to run on uClinux. gs runs without producing
any error messages, but all pages of output to any DEVICE are blank. I
am not using COMPILE_INITS=1 because of linking problems. I have my
fonts and libs in the correct dir, and gs can find them correctly. 
 
Running the following:
 
       cat waterfal.ps | gs -sDEVICE=tiffg3 -sOutputFile=file -
 
on my build system I get a file which is 47680 bytes and displays fine.
On my target system I get a file which is 8972 bytes and is blank. It
does not matter which device I use the output is always blank.
 
I have ran genarch on my target and produced a correct arch.h. I also
tried many different options from the Makefile to see if they had
anything to do with the problem (FPU_TYPE, BAND_LIST_STORAGE,
SHARED_ZLIB, ...).
 
 
-James
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ghostscript.com/pipermail/gs-devel/attachments/20070913/722db676/attachment-0001.htm